Smeg ST144 Switching Off, Annulling The Program In Progress, Modifying The Program

Models: ST144

1 27
Download 27 pages 20.11 Kb
Page 8
Image 8
SWITCHING OFF

SWITCHING OFF

The end of the washing program is signalled by a short intermittent beep and the appearance of “P0” on the DISPLAY.

ANNULLING THE PROGRAM IN PROGRESS

To annul the program being carried out, after opening the door select program "P0". When the door is closed the dishwasher will skip to the end of the program.

MODIFYING THE PROGRAM

To modify the current program, after opening the door select the new program. When the door is closed the dishwasher will start the new program automatically.

DELAYING THE PROGRAM

The start of the washing program can be delayed from a minimum of 1 hour to a maximum of 9 hours; this allows you to operate the dishwasher at the time of day of your choice.

When the DELAYED START button (3) is pressed, the DISPLAY (6) will show first the duration of the program set and then the number of hours (9,8, …1) of delay with which it is to be started.

The ANNULLING THE PROGRAM IN PROGRESS symbol will remain until the start of the washing cycle, while the number of hours will disappear automatically if the keypad is not used for 5 seconds or if any other button except the DELAYED START button (3) is pressed.

When the door is closed the dishwasher will perform a pre-wash, after which the “program delay” set previously will start. To check the time left before the program starts, simply press the corresponding button once.

If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed.

After correctly closing the door, the washing program will start again from where it was interrupted. This operation may negatively affective the progress of the washing cycle.

TABLE FOR CERTIFICATION BODIES

 

 

 

 

 

Reference standard

EN 50242

 

 

 

Reference program

 

(*) ECO BIO program (5)

 

 

 

Load

 

14 place-settings

 

 

 

Type of detergent

 

B

 

 

 

Amount of detergent

 

30 g

 

 

 

Rinse aid setting

 

Depending on the model 3/4 or 4/6

EN 50242 STANDARD LOADS

LOWER BASKET

UPPER BASKET

The cutlery basket disposes of an exclusive system of indipendent sliding flap inserts; some combinations permit to make the best of the available space.

Movement required

 

to extract the inserts

Horizontal

 

 

insert closed

Vertical

Horizontal

inserts

insert

 

open

Page 8
Image 8
Smeg ST144 instruction manual Switching Off, Annulling The Program In Progress, Modifying The Program, Delaying The Program