Installation, Removal of transport bracket

INSTALLATION

The washing machine is fitted with a transport bracket to avoid any possible damage during transport.

Before using the washing machine, the transport bracket at the back MUST be removed.

1.Unscrew the two screws A and the four screws B with a flat screwdriver or a No. 8 hex nut box spanner.

2.Remove the transport bracket.

3.Replace the four outer screws B on the machine and tighten them.

4.Remove the two seals C from the hose holder and clip them into the openings of the machine D.

Note: do not forget to replace and tighten the four outer screws.

GB 14

Image 16

Contents

GB STL Programme Chart Load Water Energy Approx. Programme Intensive Rinse buttonOne rinse cycle is added to ensure a more intensive rinse Half Load button Contents Before Using the Washing Machine Precautions and General Recommendations First Wash Cycle Description of the Washing Machine Preparation of the Washing Loading the laundry Detergents and Additives DosageFilling up with detergents and additives Choice of the right detergents and additives Programme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenser Water inlet hose filter Plug the washing machine back Water inlet hoses Washing machine does not start, no lamp lights upWashing machine does not start, but the pilot lamp is on Washing machine stops during the programme Water Stop fault may have been triggered by Water stop fault depending on modelPump operates Specify Before contacting After-Sales ServiceWait for the water to cool so as to avoid any accidents Removal of transport bracket Adjust the feet Connect the water inlet hose Water stop anti-flooding system Connect the water drain hoseDepending on model Floor Fuse replacement Valid Only For Great Britain And IrelandTo fit a new plug, proceed as follows Polarized Plugs e.g pin, 13 amp plug conforming to BS 1363A