GB
Reversing the door
The door can be changed from
1.Lay the appliance on its back with the door uppermost.
6.Loosen lock nut with the fork wrench enclosed and move the pin.
10.Remember to pull the pin in the door closer towards the side before fitting the door..
2.Remove the upper hinge.
3.Move the plastic plugs to where the upper hinge was fitted.
4.Lift off the door and lay it aside.
7.Remove the lower hinge. Rotate the hinge through 180° and refit it on the opposite side of the appliance.
8.Refit the kick plate
11.Refit the door.
12.Fit the upper hinge.
5.Remove the kick plate by pulling it outwards and upwards.
9.Remove the door closer and refit it on the opposite side.
13.Remove the door handle and refit it on the opposite side. Refit the caps.
14.The appliance must be allowed to stabilise in an upright position for at least 1 hour before being switched on.
15.After reversing the door(s), it is important to check that the sealing strip provides a tight seal all the way round. If it does not, carefully heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet.
Be careful not to heat the strip so much that it melts!
7
