GB
Thank you for purchasing your new refrigerator from Smeg. Please note that these instructions apply to all refrigerators in the SW range. Illustrations and fittings may therefore not necessarily correspond exactly to your model.
Warning
As the refrigerant used in this appliance is a flammable gas (Isobutane R600a), special care must be taken to prevent damage
to the refrigerant circuit and piping during transport and installation.
If damage does occur, avoid sparks or naked flame in the vicinity of the appliance, ensure that the room is well ventilated, disconnect the power supply, and contact your supplier.
The unit must only be serviced by quali- fied technicians from an approved service centre.
Old appliances
Old refrigerators and freezers are often fitted with complicated latches that can only be opened from the outside. If you have one of these old units stored away somewhere, or if you scrap one, remember to destroy the latch first in order to prevent children from being exposed to great dan- ger by getting locked inside the unit.
Before use
Before operating your new appliance, please read the following instructions care- fully as they contain important information on safety, installation, operation and main- tenance. Keep the instructions for future reference.
On receipt, check to ensure that the appli- ance has not been damaged during trans- port. Transport damage should be reported
to the local distributor before the refrigerator is put to use.
Remove the packaging. Clean the inside of the cabinet using warm water with a mild detergent. Rinse with clean water and dry thoroughly (see cleaning instructions). Use a soft cloth.
If during transport the appliance has been laid down, or if it has been stored in cold surroundings (colder than +5°C), it must be allowed to stabilise in an upright position for at least an hour before being switched on.
Contents |
|
Get to know your refrigerator | 3 |
Installation and | 4 |
Reversing the door | 7 |
Electrical connection | 8 |
Operation and function | 9 |
Layout and fittings | 10 |
Defrosting, |
|
cleaning and maintenance | 11 |
Fault finding | 12 |
Spare parts and service | 13 |
Disposal | 14 |
2