Smeg WCP32SB manual Installation, Selection of Room

Installation

Selection of Room

Place the appliance in a dry well-aired room. Allowed ambient temperature depends on the model (class) of the appliance and ist stated on the rating plate of the appliance.

Do not place the appliance in wet cellar, on balcony, near cooker, radiator, water heater and similar and do not expose it to direct sunlight. The appliance should be placed in horizontal position on a firm base which remains stable even after you have fully loaded the freezer.

	Class	Ambient temperature
	SN (sub-normal)	from +10°C to 32°C
	N (normal)	from +16°C to 32°C
	ST (sub-tropical)	from +18°C to 38°C
	T (tropical)	from +18°C to 43°C
Cooling of the Appliance
		Connection to the Mains Supply

The appliance is not intended to be built-in the kitchen cabinet.

Provide for enough space on either side of the appliance (2-3 cm) for unobstructed air circulation.

Cooling of the rear of the appliance is of special importance.

ξ Freezers having the switches in the front, can be pushed up to the wall as the hinges of the lid define the minimum required distance between the wall and the appliance.

ξ Freezers having the switches in the lid are equipped with two spacers. Insert them into the holes on the rear side in order to determine the right distance of the appliance from the wall.

Connect the appliance with the cable and plug to the mains supply socket with a ground terminal (safety socket).

Required nominal voltage and frequency are indicated in the rating plate.

The connection to the mains supply and earthing of the appliance have to be made according to valid standards and regulations.

The appliance resists temporary voltage fluc- tuations but only in the tolerance of -15 to +10%.

38 Instructions for Use