| GB |
|
|
11 | The machine does not spin The unbalanced load sensor has triggered because the washing is not |
| unif ormly distributed inside the drum. If the washing is wet at the end of |
the cycle, distribute it well inside the basket and repeat just the spin cycle.
12Draining water from the drum
13The washing has not been correctly spun
14Residues of detergent on the washing
15The washing does not dry
16Washing results are unsat- isfactory
In the event of a power f ailure or a fault in the appliance, the water inside the drum can be drained as described in paragraph 6.3
Large items have rolled up and are not unif ormly distributed inside the drum. Always wash large items together with small ones.
Many
Select the Rinse programme or brush the washing. Check that:
-the water tap is open
-the washing does not weight too much
-the dry ing time is suitable.
-suff icient dry ing time has been selected
If the machine does not dry all the same, call the Serv ice Centre to re- mov e fabric f rays f rom the fan and dry ing ducts.
-Too little detergent or an unsuitable detergent may hav e been used.
-Stubborn stains were not
-The wrong temperature was selected
-The drum was overloaded
ERROR SIGNALS
In the ev ent of faults, the machine will display an error code.
Error code | Problem |
Door not closed properly. Close it.
Aquastop. Contact the nearest Serv ice Centre after disconnecting the machine from the electrical power supply and closing the water tap.
No water for washing. See point 2 on the troubleshooting table.
The water does not drain. See point 4 on the troubleshooting table.
For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing the water tap.
29
