Smeg WDI16BA instruction manual Fitting the Furniture Doors

GB

3.7 FITTING THE FURNITURE DOORS

Once the washer dry er has been correctly installed and commissioned, the f urniture door can be f itted following the dimensions on the template and the instruction enclosed in the washer dry er packaging.

Please note that only f urniture doors of a thickness between 16mm and 21mm are compatible with this washer dry er.

Important – The machine complies with the current safety provisions governing electrical equipment. It must be installed by a specialised technician in compliance with the current standards in order to prevent it from becoming a potential danger for the user.

3.7.1How to fit the furniture door

The f urniture door that cov ers the front can be hinged on either the left side or right side.

For pratical reasons, it is adv isable to maintain the same opening direction as the glass door (with hinges applied to the left-hand side).

The appliance has hinge supports on the lef t-hand side, whilst the push-push closing system is mounted on the upper right-hand part.

If the magnetic closing mechanism is required, remov e the existing component (B) and install the component (D) as illustrated below.

Important! Ensure that the appliance is disconnected from electricity supply before installing the furniture door (during which all hinging and closing mechanisms must be removed from the front) on to the washer dryer).

Warning – To hinge the panel on the right-hand side (opening direction opposite to that of the glass door), completely remov e the hinge supports (A), the closing hook (B), the lower bearing plug of the rubber plug (C) from the f ront part of the machine and fit them to the opposite side.

All parts fitted to the front of the washing dryer must be correctly remounted (no hole must be left open). This will prev ent users f rom touching liv e parts of the appliance.

Our company declines all responsibility for damage caused by failure or negligence in complying with these safety provisions.

9