Connection to Power Supply
Connect the appliance to the power supply with a cable cord. The wall socket should be equipped with an earth contact (safety socket).
Fixed connection should be carried out by an expert.
Rated voltage, frequency and other data are listed on the rating plate of the machine.
Your washing machine should be grounded and connected to the power supply according to local electricity board regulations and standards.
WARNING!
In the supply cord is damaged, it must be replaced by the manufacturer or his service agent or a qualified person in order to avoid hazard.
•The appliance should be placed in the position, where the plug is within reach.
The Door
The door can only be opened two minutes after the washing programme has finished.
Open the door by pulling the door handle (fig. 9).
When closing the door, push it towards the machine until it locks (fig. 10).
If the door is not correctly closed, the machine will not operate.
Direction of Opening the Door
Certain models of appliances allow the possibility of changing the direction of door opening. This is an option that has to be ordered separately and paid for by the customer.
9 |
10 |
IMPORTANT
•When closing the door, be careful not to trap fabric between the door glass and the rubber gasket.
•If you need to open the door after the machine has been switched on, first switch it off and wait for about two minutes.
When opening the door, be careful, as the water level may be high and water may pour out when you open the door.
•Don't even try to open the door while the machine is operating.
•If the machine won't start after switching on, push the door once again towards the machine (at handle).
•An inadequately closed door is the most common cause of malfunctions.
56 | Instructions for Use |
