DEFINITY AUDIX System Power

C

Procedures

 

Manually Power Down DEFINITY

AUDIX System

A yellow caution sticker is placed on the switch’s power unit telling technicians to shut down the DEFINITY AUDIX System prior to powering down the switch.

To shutdown the DEFINITY AUDIX system, do the following:

1.Using a pointed object, such as a paper clip or pen (do not use a pencil), press the Boot/Shutdown button (See A on Figure C-1).

2.Hold Boot/Shutdown button in until Liquid Crystal Display (LCD) (see B in Figure C-1)flashes the message: MSHUT.

3.Release Boot/Shutdown button.

NOTE:

DEFINITY AUDIX System takes approximately five minutes to shut down. The following sequence of events will happen during shutdown:

Display (See B on Figure C-1)flashes the message: MSHUT.

About two and a half minutes into shutdown, the display flashes the message, TEST, and the red light emitting diode (LED) (See C on Figure C-1)is steady on.

The DEFINITY AUDIX System is now powered down.

Issue 1 September 1995 C-1

Page 221
Image 221
AT&T 555-230-894 manual Definity Audix System Power Procedures, Manually Power Down Definity Audix System