Install Ground Plates

See Figure 4-22and Figure 4-23for illustrations of the ground plate and cable clamp positions.

Install Ground Plates on Systems with

Earthquake Protection

Refer to Appendix B for earthquake protection procedures.

Install Ground Plates on Systems without

Earthquake Protection

A ground plate is required to connect each cabinet together (see the following figures). To install the ground plate, complete the following steps:

1.At the back of the cabinets, replace the upper and lower panels (allowing the screws labelled with callout 4 to remain loose). See Figure 4-21.

 

3

2

4

4

 

1

Figure Notes:

1.

Cabinet in A position

3.

Cabinet in B position

2.

Ground plate to attach between cabinets

4.

Screws to loosen

Figure 4-21. Back Panel Screw Locations

Issue 1 September 1995 4-31

Page 71
Image 71
AT&T 555-230-894 manual Install Ground Plates on Systems with Earthquake Protection, Back Panel Screw Locations