AT&T 555-230-894 manual Set Up G3 Management Terminal G3-MT

Install Generic 3 Management Terminal

Set Up G3 Management Terminal (G3-MT)

Use the following procedures to set up the 715 Management Terminal options:

NOTE:

These procedures may change as the model of 715 Management Terminal (G3-MT) shipped with DEFINITY System Generic 3 changes. Consult the documentation shipped with the terminal for set up instructions.

1.Hold down the CTRL key while pressing F1 and verify the terminal setup screen is shown.

Function keys (F1, etc.) are located at the top of the keyboard of the terminal. Lighted rectangles (windows) appear at the bottom of the screen and correspond to the function keys across the top of the keyboard.

2.Press F7 to make sure the default values are set.

3.Using the up/down arrow keys on the keypad, position the cursor at the

Keyboard Options (per window) field and press RETURN.

4.Using the up/down arrow keys on the keypad, position the cursor at the Enter Key field. Then under Primary/Window 1 press the ESC key, then hold down the SHIFT key and type S and then B. This will enter escapeSB in this field.

5.Press F5-SAVEto save the changes then press F1 SETUP MENU and exit the Setup Menu screen.

Table 6-1. Required Settings for 715 Management Terminal to Communicate with Switch

Terminal Option	Value
Font Size	Large (default)
Autowrap	Off (default)
Baud Rate	9600 (default)
Stop Bit	1 (default)
Data Bits	7 (default)
Parity	Space (default)
Check Parity	Yes (default)
Transmission Flow Control	X on, X off (default)
Enter Key	escapeSB (must be set)

6-6Issue 1 September 1995