AT&T 555-230-894 manual Check Circuit Pack Configuration Again

Check Circuit Pack Configuration Again

status system all-cabinets					SPE B
		SYSTEM STATUS	CABINET 1
EMERGENCY	SELECT		SERVICE		CABINET
TRANSFER	SWITCH	EXP-LINK	STATE	MODE	TYPE
1A	auto-on	01A01-02A01	in	active	MCC
1B	auto-on	01B01-02B02	in	standby

Screen 8-17. Example of System Status after Expansion Link is Set

6.Verify the MODEs of the expansion links have changed.

7.If any problems are indicated, check the Time Division Multiplexing (TDM) cables and the inter-cabinet cables (ICC) in the associated Expansion Port Network (EPN).

Check Circuit Pack Configuration

Again

Review the circuit packs contained in the system to ensure all circuit packs are displayed on the screen.

1. Verify the screen displays:

command:

2.Type list configuration all and press ENTER.

3.Verify all circuit packs installed in the system are listed in the reports.

Refer to the U.S. English book, DEFINITY Communications System Generic 1 and Generic 3i Maintenance, 555-104-205, to resolve any discrepancies.

Issue 1 September 1995 8-19