Install the 1145B1 Power Supply
Mount the 1145B1 Power Supply
The 1145B1 Power Supply unit is
1.Perform this step using a "place, rotate, then snap" motion. The holes used for 1145B1 Power Supply mounting are indicated on the wall- mounting plate. The preceding illustration shows a side view of the mounting arrangement.
To dismount the unit, push the bottom of the power unit toward the mounting plate while pressing the two snaps on the bottom. Rotate upward and lower the unit.
1 | 2 |
| |
| 3 |
| 4 |
| 5 |
| 6 |
| 7 |
| 8 |
| 9 |
Figure Notes:
1. | 3/4 inch (2 cm) Plywood | 6. | Snap |
2. | AC Receptacle | 7. | To Approved Ground |
3. | 1145B1 Power Unit | 8. | Wall Mounting Plate |
4. | Frame Ground | 9. | Power Cord |
5. | 16 AWG Installer Wiring |
|
|
Figure 9-13. Side View of 1145B1 Power Supply Mounting
Issue 1 September 1995
