AT&T 555-230-894 manual Install Telecommunications Cabling, Install the Cross-Connect Field

Install Telecommunications Cabling 5

This chapter describes how to install telecommunications cables and cross- connect equipment.

The specific equipment being installed varies on what was ordered for your site. Use the material presented in this chapter as an example.

Install the Cross-Connect Field

This section describes how to connect to the cross-connect field.

Typical Cross-Connect Field Using

110-Type Hardware

The cross-connect field is normally located directly behind the switch cabinet. Figure 5-1shows a typical cross-connect field installation using 110A-type terminal blocks. Allow at least 3 feet (1 meter) between the back of cabinet and the 110-type hardware.

Issue 1 September 1995 5-1