AT&T 555-230-894 manual Unpack the Cabinet, Unpack and Inspect for Damage

Unpack the Cabinet 3

This chapter describes the system unpacking procedures.

The DEFINITY System Generic 3 (G3) single-carrier cabinets are shipped in a polyethylene bag, packed in a cardboard container. The cabinet is fastened to a wood/Styrofoam pallet with two metal bands. The cardboard container is strapped to the pallet with another metal band.

! DANGER:

Lifting the cabinet requires two people, as it may weigh as much as 130 pounds/60 kilograms. Use caution to avoid injury.

Unpack and Inspect for Damage

Unpacking the Cabinets

To unpack the cabinets, complete the following steps:

1.Check the status of the SHOCKWATCH and/or TILTWATCH indicators on the cardboard container. These indicators are white under normal conditions. If the container has been shaken or tilted beyond specifications, the indicators will be red, indicating potential damage. Report any damage according to local shipping instructions.

2.Remove the cabinet from the cardboard container.

! DANGER:

Take care to avoid injury while cutting and removing bands.

3.Remove all cardboard, tape, and plastic.

September 1995 Issue 1 3-1