AT&T 555-230-894 manual Issue 1 September 1995 IN-7

Index

power up

AC-powered switch, procedure, 7-3AUDIX procedure, C-1DC-powered switch, procedure, 7-3

PPN cabinet installing, 4-2

printer

475 switch settings, H-21

572 option settings, H-30connecting to G3MT, 6-2journal option settings, H-21option settings, H-20parallel, 6-2

serial, 6-2

processor interface circuit pack AUDIX connections, H-36switch settings, H-2

processor port network, duplication, 1-1protection

earthquake, B-1electromagnetic, B-4

provisioning plan, 2-9

Q

queue warning indicator, test procedure, 10-10

R

REBOOT PERFORMED, 7-4

recorded announcement, test procedure, 10-12red lights

what to do about, 7-8refresh spe command, 8-13reliability

critical, 1-1,1-2

testing systems, 8-11,8-12,8-17high, 1-1,1-2

testing systems, 8-11,8-12overview, 1-1

standard, 1-1,1-2

remote access, test procedure, 10-14Report Scheduler, system printer, H-21required hardware

by country, D-1–D-19requirements

country hardware for grounding, A-1protective grounding, A-1

reset system interchange command, 8-13RF shielding, 4-35,B-4

ringing

external, test procedure, 10-9night, test procedure, 10-9

routing cables, 5-3

Russia

country code, 7-8required hardware, D-14

RX connector, 4-19

S

Saudi Arabia
country code,		7-8
required hardware,				D-15
save translations,		7-15
screens
G3MT introduction,				7-4
screws, thread-forming,				B-2,B-4
selector console, test procedure,							10-9
serial printers,	6-2
set expansion-link command, 8-18
set tone-clock command,					8-17
setting
bit rate, H-41,H-42
line impedance,			H-41,H-42
setting date and time, procedure,							7-11
shadow link
test procedure,			8-11
shielding, electromagnetic,						4-35,B-4
Shockwatch
trademark information,					xvii
signaling leads, DC power,						H-37
signaling, bit-oriented,				H-41
Singapore
country code,		7-8
required hardware,				D-16
single-point ground terminal,						A-2
site planning and preparation
overview, 1-3
procedure, 2-1
slack manager
floor plan including,				2-2
Slovakia
required hardware,				D-6
SMDR, H-20
option settings,			H-34
output receiving device,						H-35
printer, H-30
Spain
country code,		7-8
required hardware,				D-16
SPID
test procedure for,				10-16
stabilizing cabinets,			4-35
for earthquakes,			B-4,F-1
standard reliability,			1-1,1-2
standby power,	4-14
Station Message Detail Recording (SMDR), H-20
status system all-cabinets
command,	8-1,8-12,8-17,8-18

Issue 1 September 1995 IN-7