Connect Battery Leads

Connect Battery Leads

To prevent the batteries from discharging, the control cabinet is shipped with the battery lead disconnected. To connect the batteries, perform the following:

At cabinet(s):

1.Ensure the circuit breakers on each cabinet are OFF.

Each cabinet has its own power supply and the circuit breaker is located on the rear of each power supply. See Figure 4-3.

2.Connect the battery lead:

See Figure 4-3.The battery is near the top of the carrier toward the front- right. The battery leads should be immediately next to the battery, on the left side, and accessible from the front of the cabinet.

1

2

3

Figure Notes:

1.Battery

2.Circuit Breaker

3.Ground block

Figure 4-3. Single Carrier Cabinet Control Cabinet

Battery Location, Right Side View

Issue 1 September 1995 4-5

Page 44 Page 46
Page 45
Image 45
AT&T 555-230-894 manual Connect Battery Leads
Page 44 Page 46
Top Page Image Contents