Install Telecommunications Cabling
4 | 4 |
2
1
4 | 3 |
|
| ||
4 | |||||
| |||||
|
|
|
|
| |
|
|
|
|
| |
4 |
|
| 4 | |
|
|
|
|
|
|
|
|
|
|
5 |
|
| 5 | |
|
|
|
|
|
|
|
|
|
|
Figure Notes:
1. | B25A cables | 3. | |
2. | Loop and Drape Excess | 4. | Port Cabinet |
| Cable. Do Not Route | 5. | Control cabinet |
| and B25A Cables Together. | ||
|
|
|
Figure 5-3. Typical Port Cable Installation at Switch Cabinet
Connect Control Carrier Outputs
Cable
Plug the connector cable in the AUX connector on the rear of the control carrier. Route the connector cable through the cable slack manager to the assigned connecting block in the yellow field of the trunk/auxiliary field.
Refer to Table
The output wiring connections for the Initialization Administration System (INADS) trunk interface are described in "Install Initialization and Administration System (INADS) Interface" on page
