Install Front Plates

Install Front Plates

The front plates provide electromagnetic radiation and radio frequency (RF) shielding and earthquake protection.

If you do not have a requirement for electromagnetic radiation shielding, radio frequency shielding, or earthquake protection, use the cabinet clips as described in this section.

Install Front Plates on Systems with

Earthquake Protection

Refer to Appendix B to install the front plates to help provide earthquake protection and radiation shielding.

Front plates are used in place of cabinet clips (as described in Appendix B), for earthquake protection.

Install Cabinet Clip On Systems without

Earthquake Protection

A cabinet clip is required between each cabinet to stabilize the cabinets.

1

Figure 4-24. Cabinet Clip

At the front of the cabinets, install a cabinet clip (Figure 4-24)between each cabinet by hooking the clip into the slot of the upper cabinet and snapping the straight leg of the clip into the slot on the lower cabinet (see Figure 4-25).

Issue 1 September 1995 4-35

Page 75
Image 75
AT&T 555-230-894 manual Install Front Plates on Systems with Earthquake Protection