AT&T 555-230-894 manual Option Switch SettingsH

Option Switch SettingsH

Some of the interface units used between the single-carrier and multi-carrier cabinets and other types of equipment require specific option switch settings for each application. This section lists the option switch settings required for modular processor data modules, modular trunk data modules, modems, printers, etc., when these units are used with the switch. Only the option switch settings for use with single-carrier or multi-carrier cabinets are shown. Refer to the User Guide on each type of equipment for information on how to locate and set the option switches.

Distributed Communications System (DCS) Option Settings for G3i Systems

The distributed communications system (DCS) is sometimes connected to the switch through the processor interface circuit pack. The first circuit on the processor interface can be connected directly to the distributed communications system (DCS) through the PROCESSOR INTERFACE connector on the rear of the control carrier. Any of the remaining three circuits on the processor interface used to support the distributed communications system (DCS) must be

September 1995 Issue 1 H-1