Connect Generic 3 Management Terminal G3-MT

Install Generic 3 Management Terminal

Mains power for the terminal must be obtained from a standard voltage source in the range of 115 to 230 volts AC in the equipment room. The terminal is auto-sensing and automatically adjusts to receive the type of AC power at the site.

An optional printer may be used with the terminal to provide hard copies of administration data. A parallel printer should be connected to the printer or PAR port. A serial printer should be connected to the Data Communication Equipment (DCE) port.

Always connect the terminal cable to the Data Terminal Equipment (DTE) port on the back of the terminal. See Table 6-1.

1	2	3

	P1-DCE	P2-DTE
PAR	AUX Port	MAIN PORT

Figure Notes:

1.Parallel port to which optional parallel printer is connected.

2.Data Communication Equipment (DCE) port to which optional serial printer is connected.

3.Data Terminal Equipment (DTE) port to which cable from switch is always connected. No matter what the position of the Data Terminal Equipment (DTE) port, always connect the cable from the switch to the port.

Figure 6-1. Partial Rear View of one version of the 715

Management Terminal (715 MT)