Basic Lighting Procedures
Machine oils used in the manufacturing process of stainless steel can cause stainless steel to tum a tan
color. Before initial grill use, remove protective PVC film from Control Panel and inside and outside of Grill Lid.
Use a Stainless Steel Cleaner to polish the stainless steel and remove these excess oils from your grill. Never use abrasive cleaners or scrubbers because they will scratch and damage your grill. For details, see Cleaning Exterior Stainless Steel Surfaces on page 27.
Gas Lighting Instructions
Familiarize yourself with the safety guidelines at the front of this manual. Do not smoke while lighting grill or checking gas supply connections.
1.If you have a LP gas grill be sure the LP gas tank is filled, or if you have a NG grill be sure that the locking shut off valve is open.
2.Check that the end of each Burner Tube is properly located over each Valve Orifice.
3.Be sure all gas connections are securely tightened.
4.Open the Grill Lid or Side Burner Lid, depending on the Burner you are lighting.
Z WARNING
Failure to open Grill Lid during the lighting procedures could result in a fire or explosion that could cause serious bodily injury, death, or property damage.
5.Set ALL Control Knobs to OFF and open the LP gas tank valve slowly until 1/4 to 1/2 open.
Open LP gas tank
OFF
\
6.Push and turn the any Control Knob for Main Burner to HIGH.
HIGH
LEFT ELECTRIC
OFF_GNITOR
°_ | _, | ,©, |
7.Immediately press the left Electric Ignitor for
"-_. PRESS LEFTELECTRIC
IGNITOR
. If the burner does not light, turn the Control Knob to OFF, wait 5 minutes for gas to clear, then retry.
g.Once the grill burner is ignited, the adjacent burner can be lit by simply turning its Control Knob to HIGH.
10.Adjust Control Knobs to your desired cooking temperature.
Side Burner Lighting Instructions
1.Follow steps 1 through 5 of the Basic Lighting
Procedures.
2.Push and turn the control knob (on the right side burner frame ) for Side Burner to HIGH.
HIGH
RIGHT ELECTRIC
OFFiGNITOR
(for SIDE BURNER)
\
©,
©©
. Immediately press the right electric ignitor for
4.If the burner does not light, turn the control knob to OFF, wait 5 minutes for gas to clear, then retry.
5.Adjust control knobs to your desired cooking temperature.
MAIN BURNER | 24 |
