Kenmore 141.15337, 141.17337 Electrode Check Requires an Assistant, Customer Service Helpline at

Ignitor Battery Installation - See Fig. 9

1.Unscrew both Ignitor Caps located on the grill Control Panel and remove the Contact and

Spring from each Ignitor Slot.

2.Place the manufacturer supplied AA battery into each Ignitor Slot. Be sure to place the

_ po_ &c_g _L_:]. _OL_.S_ Fig. 9

3.Place the Spring over the AA battery, then place the Contact on top of the Spring. Screw the Ignitor Cap back onto the grill Control Panel.

4.Remove any protective film from outside and inside of Grill Head.

IMPORTANT: Before use of this grill please refer to Cleaning Exterior Stainless Steel

Surfaces found on page 27 of this Owner's Manual.

Figure 9

IGNITOR SLOT

IGNITOR CAP,

SPRING

CONTACT

Electrode Check - Requires an Assistant

Before placing the cooking components into your

grill, ensure that the Spark Electrode Tip is properly positioned within each Gas Collector Box ( a

3-1/4" wide stainless mechanism found at the front between each set of Burners.) The easiest way to ensure this is to perform this Electrode Check:

1.Be sure all Control Knobs are set to "OFF" and open the Grill Lid.

2.Have an assistant stand behind to the right of the grill and look down at each Gas Collector Box. NEVER put your face inside Grill Head.

3.Press the Ignitor Cap. You should hear a "clicking" sound and your assistant should see a small blue spark within each Gas Collector Box. If a spark is present the Electrode Tips are properly positioned.

4.If no spark is seen the Spark Gap shown in Fig. 10 needs to be adjusted as follows:

Using an adjustable wrench, loosen the Inside Nut just until the Gas Collector Box can be maneuvered and turned upward.

The gap between the Spark Electrode Tip and Spark receiver should be approximately 3/16".

If the gap is wider than 3/16" use a pair of long nose pliers and gently squeeze the Gas Collector Box until the gap is correct.

Return the Gas Collector Box to its original horizontal position, secure the Inside Nut and try the Electrode Check again.

5.If no "clicking" sound is heard check the following common causes. If you need assistance call our

Customer Service Helpline at 1-888-317-7642.

•Ignitor AA battery not installed properly.

Ignitor wires may be loose. Remove the AA battery, inspect the Ignitor Junction Box found

behind the Control Panel, and connect any loose wires.

Figure 10 - Side View Figure

GAS COLLECTOR BOX

19