Connecting A Liquid Propane Gas (LP gas) Tank To Your Grill
1.Open the front Doors of cabinet. Pull out the LPG Tank
Fig.13a. Make sure the tank valve is in the OFF positon.
2.Align the tank so the Tank Valve faces the rear right comer of cabinet. Use the
5/16"x89mm Wing Bolt to secure gas tank from rear of tray.See Fig. 13a.
3.Check the tank valve to ensure it has proper external mating threads to fit the hose & regulator assembly provided (Type 1 connec- tion per ANSI Z21.58a-1998). See Fig.13b
4.Inspect the valve connection port of the regulator assembly. Look for damage or debris. Remove any debris. Inspect hose for damage. Never use dam- aged or plugged equipment.
5.Make sure all Burner knobs are in the OFF position.
6.Connect the hose and regulator assembly to the tank
valve (See Fig 13b) Hand tighten Quick Coupling Nut clockwise to a full stop. DO NOT use a wrench to tighten because it could damage the Quick Coupling Nut and result in a hazardous condition.
7.Open the tank valve fully (counterclockwise). Use a soapy water solution to check atl connections for leaks before attempting to light your grill. See "Check- ing for LP Gas Leaks" on page 20. Ifa leak is found, turn the tank valve off and do not use your grill until the leak is repaired.
Disconnecting A Liquid Propane Gas (LP gas) Tank From Your Grill
1.Turn the Burner Knobs and LP gas tank
valve to the full OFF position. (Turn clockwise to close.)
2.Detach the hose and regulator assembly from the LP gas tank valve by turning the Quick Coupling Nut counterclockwise. See Fig.13b
CAUTION: When the appliance is not in use, the gas must be turned off at the supply tank.
Figure 13a (LP gas model only)
GRILL
HEAD
FRONT
DOOR
GAS
TANK
5/16'*x89mm | |
TRAY | WING BOLT |
Figure 13b (LP gas model only)
GRILL
HEAD
FRONT
DOOR
TANK
TRAY
Type 1 | QUICK |
|
connection | COUPLING | ALREADY CONNECTED |
per ANSI | NUT | TO ADAPTOR UNDER |
| SIDE BURNER. |
22
