6.For Natural Gas grills:
Connect the Ignition Wire terminal from Side Burner with the other from Grill Head. See Fig. 8d. Bind the connected Ignition Wires, and Connection Tube together using the supplied Fastening Band.
7.The gap between the Side Burner Electrode Tip and the Side Burner Port should be approximately 1/8"~3/16 ''See. Fig. 8e.lf the gap is wider than 3/16", use a pair of long nose pliers and gently bend the Electrode Tip toward the Burner.
8.Slide the 5 Tool Hooks onto the Tool Holder with hooks facing the grill Head. Attach Tool Holder to left side of Side Shelf and secure firmly using 2 of the M5x8mm Pattern Head Screws and washers supplied. See Fig. 8f.
•When you have finished assembling your grill we strongly urge that all Pattern Head Thumb Screws be tightened, either with the supplied Tightening Tool or a #2 Phillips Head Screwdriver.
Tightening Tool
Ref. # P05515102K
9.For Natural Gas grills:
Connect the hose end of the 12' Natural Gas Hose to the vertical fitting as shown in Fig. 8g. Also read the natural gas safety instruc- tions. (on page 4)
Figure 8g (Natural gas model only)
| GASVALVEFOR |
BRASS | SIDE BURNER |
ADAPTOR |
|
12'NATURAL
GAS HOSE
CONNECTION
TUBE FROM
GRILL HEAD
Figure 8d (Natural gas model only)
POT
SUPPORT
SIDE
|
| COTTER |
|
| PIN |
CONTROL | SIDE | BURNER |
KNOB_ | FRAME | |
| VALVE | KIT |
FASTENING |
|
|
BAND _ |
| WIRE |
FROM SIDE BURNER
IGNITION WIRE
FROM GRILL HEAD
Figure 8e
I/8"_3/16"BURNER
Figure 8f
TOOL HOOK
TOOL HOLDER
M5xSmm PATTERN
HEAD SCREW
SIDE SHELF
18
