2450 PSI Pressure Washer
4.Slide adjustable nozzle forward to low pressure mode. Detergent cannot be applied with nozzle in high pressure position.
5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump. Start engine.
6.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
7.Allow detergent to "soak in" for
IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for
Pressure Washer Rinsing
For Rinsing:
1.Slide nozzle backward to high pressure, squeeze trigger and wait for detergent to clear.
NOTE: You can also stop detergent from flowing by simply removing chemical injection hose from bottle.
2.Keep spray gun a safe distance from the area you plan to spray.
WARNING
High pressure spray could cause you to fall if you are too close to the cleaning surface.
•Keep spray nozzle between 8 to 24 inches away from cleaning surface.
•Operate this unit on a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
3.Apply a high pressure spray to a small area, then check surface for damage. If no damage is found, it is okay to continue cleaning.
4.Start at the top of the area to be rinsed, working down with same overlapping strokes as you used for washing and applying detergent.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
discharging the warm water onto the ground.
11
