Snapper 020229 Troubleshooting, Problem, Cause, Correction, Pump has following problems

2450 PSI Pressure Washer

TROUBLESHOOTING

Problem	Cause		Correction
	1.	Nozzle in low pressure mode.	1.	Pull nozzle backward for high
				pressure mode.
	2.	Water inlet is blocked.	2.	Clear inlet.
	3.	Inadequate water supply.	3.	Provide adequate water flow.
	4.	Inlet hose is kinked or leaking.	4.	Straighten inlet hose, patch leak.
Pump has following problems:	5.	Clogged inlet hose strainer.	5.	Check and clean inlet hose
failure to produce pressure, erratic				strainer.
pressure, chattering, loss of	6.	Water supply is over 100°F.	6.	Provide cooler water supply.
pressure, low water volume.	7.	High pressure hose is blocked or	7.	Clear blocks in outlet hose.
		leaks.
	8.	Gun leaks.	8.	Replace gun.
	9.	Orifice is obstructed.	9.	Clean orifice.
	10.	Pump is faulty.	10.	Contact Briggs and Stratton Power
				Products service facility.
	1.	Detergent siphoning tube is not	1.	Insert detergent siphoning tube
		submerged.		into detergent.
	2.	Chemical filter is clogged or	2.	Clean or replace filter/detergent
Detergent fails to mix with spray.		cracked.		siphoning tube.
	3.	Dirty in-line filter.	3.	See "Check In-Line Filter".
	4.	Nozzle is in high pressure mode.	4.	Push nozzle forward for low
				pressure mode.
	Engine speed is too slow.		Move throttle control to FAST
Engine runs good at no-load but			position. If engine still "bogs down",
"bogs" when load is added.			contact Briggs and Stratton service
			facility.
Pressure washer stops during	Out of gasoline.		Fill fuel tank.
operation.

16