2650 PSI Pressure Washer
7.Allow detergent to soak in between
IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for
Pressure Washer Rinsing
For Rinsing:
1.Apply safety latch to spray gun.
2.Remove black chemical nozzle from nozzle extension.
3.Select and install desired high pressure nozzle following instructions “How to Use Spray Tips”.
4.Keep spray gun a safe distance from the area you plan to spray.
WARNING
High pressure spray could cause you to fall if you are too close to the cleaning surface.
•Keep spray nozzle between 8 to 24 inches away from cleaning surface.
•Operate this unit on a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
5.Apply a high pressure spray to a small area and then check the surface for damage. If no damage is found, you can assume it is okay to continue rinsing.
6.Start at top of area to be rinsed, working down with same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it with clean water before stopping the engine.
1.Place chemical injection siphon/filter in a bucket full of clean water.
2.Attach black low pressure spray tip.
3.Flush for
4.Shut off engine.
IMPORTANT: Simply shutting OFF engine will not release pressure in the system. When the engine has shut down, squeeze the trigger on the spray gun to relieve the pressure in the hose.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
discharging the warm water onto the ground.
12
