Snapper 020230 user manual Add Engine Oil and Fuel, Connect Hose and Water Supply to Pump

2650 PSI Pressure Washer

3.Insert one “L” hook through hole just above billboard on left side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.

Figure 3 — Attach “L” Hooks to Handle

Spray Gun Hook

Hose Hook

4.Insert other “L” hook through hole just below billboard on right side of handle (viewing from front of unit). Hold hook in place and attach a plastic knob from inside of unit (Figure 3).Tighten by hand.

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine user’s manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine user’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine user’s manual for recommendations.

Connect Hose and Water Supply to Pump

IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.

1.Uncoil high pressure hose and attach one end of hose to base of spray gun (Figure 4).Tighten by hand.

Figure 4 — Connect High Pressure Hose to Spray Gun

Connect high pressure hose here

2.Attach other end of high pressure hose to high pressure outlet on pump (Figure 5).Tighten by hand.

Figure 5 — Connect High Pressure Hose to Water Outlet

7