g. Using the front trunnion (Y; figure I), connect the cylinder and lift rod(G) to the tractor lift lever. (See figure 4.) Position cylinder and insert short leg of trunnion through it. Connect lift rod to long leg of trunnion. Be sure lift rod is positioned with flat side as shown.
VIEWED FROM TOP
~FRONT -
a. Remove and discard the
b. Install the plate in mounting holes (C, figure 7)
shown. Use
Figure 4.
2.For 18 hp models, Mfg. No. 1691307, and older, install special washer (CC, figure 1) as follows:
a . Remove cotter pin (A, figure 5) and remove ground speed control rod (B) from cam plate (C).
b. Install special washer (D) on control rod (B). Reinstall rod to cam plate and secure with cotter pin.
Figure 5. Special Washer Installation
A. Cotter Pin
6.Ground Speed Control Rod C. Cam Plate
D. Special Washer
Figure 6.
VIEWED FROM LEFT SIDE
3 . If a rear PTO has been installed on the tractor, it is not necessary to install the upstop plate (0, figure 1). To install, proceed as follows:
Figure 7.
A. Lift Shaft Mtg. Holes 6. Hitch Mtg. Holes
C. Upstop b’late Mtg. Holes D.~sSrwv,
2
