4.Insert the lift shaft (A, figure 8) into position, place bearing (B) on to each end, and secure with capscrew lockwasher and nut (C) on each side.
5.Position the rear tnmnion (D) onto thelift rod. Install the lift arm half(E) to lift shaft(F) and secure with two
3/8-16x l”capscrews, 3/8”lockwashers and3/8”nuts
(G). Install centerlock nut on end of lift rod.
7.From top, connect hitch~(A) to drawbarwith two l/Z- 13 x
nuts.
8. Reinstall panels and cover removed in step 1.
Figure | 8. |
|
|
A. Lift | Shaft | E. Lift | A& |
S. Searing~~ | |||
C. Mtg. Hardware | F. Lift | Shaft | |
D. Rear Trunnion | G. Mtg. Hardware | ||
6.Position the hitch (A, figure 9) as shown and install
two
7).
Figure 9.
A.Hitch
S. Mtg. Hardware c . Capscrew
