Attaching & Removing the Turbo
ADJUSTMENTS
Pulley Adjustments
If the mower deck belt has stretched over time, the stacked idler pulley (B, Figure 10) may need to be moved to the outer hole in the mower deck to take up the belt slack.
If the mower idler pulley (B) is mounted in the outer hole in the deck, then the turbo idler pulley (C) should be as far toward the front as the slot will allow. If the stacked idler pulley (B) is mounted in the inner hole, then the turbo idler pulley (C) should remain as installed at factory.
To adjust:
1.Loosen the
2.Move the idler pulley forward in the adjustment slot and then
F | E |
| |
| D |
| A |
C | B |
Figure 9. Mount/Remove Turbo
A. Mounting Plate | D. Idler Release Lever |
B. Hairpin Clip | E. Upstop |
C. Belt Cover Knob | F. Deflector |
Upstop Adjustment
The upstop (E, Figure 9) prevents the deflector (F) from contacting the top of the turbo. If the upstop is not pro- viding sufficient clearance, shim the upstop with washers until the deflector does not contact the turbo.
STORAGE
Remove any debris from the turbo blower housing. If you clean the housing, use a mild detergent only (other prod- ucts may damage tube). If paint has been scratched on metal parts, touch up with paint, or apply a thin film of oil.
To prevent corrosion, store in a dry area, away from moisture.
B |
A |
F |
C |
Adjustment Slot |
D |
E |
FRONT |
Figure 10. Turbo Belt Routing
A.Belt
B.Stacked Idler Pulley
C.
D.Turbo Drive Pulley
E.Spring Loaded Idler
F.Capscrew,
8