Assemble & Install Deflector
1.The two holes for mounting the deflector must be drilled out. Turn the deflector over, and notice that these two holes are started. Finishing drilling the two 11/32 inch holes (See Figure 4).
2.See Figure 4. Connect the deflector (A) to the deflec- tor brackets (O) with two
3.Install two
4.Mark and drill two 13/32 holes (S & R) in mower deck. Use Template on page 9. Attach the front pivot bracket (B) using
Initial Setup & Assembly
5.Attach the back pivot bracket (C) to the existing hole in the mower deck formerly used to mount the deflec- tor rod. Attach using
6.Use the hinge rod (D) to align the front and back pivot brackets (B and C) as shown.
7.Using the bracket for guidance, drill out hole “Q” using a 13/32” drill.
8.In the new drilled hole,
9.Install the deflector (A) assembly. Insert the rod (D) through the brackets (B, O, and C) and spring (E). Secure with a cotter pin at each end.
10.Hook the spring on the rear deflector bracket (O),
|
|
| N | C |
|
|
| M |
|
|
|
| E |
|
|
|
|
| Hole “P” |
| B |
|
|
|
N |
| K | J | Hole “Q” |
|
|
| ||
|
|
| L | |
|
|
|
| |
M |
|
|
| I |
|
|
|
| O |
Hole “R” |
|
|
|
|
D |
|
|
|
|
|
|
| H |
|
|
|
| G |
|
L |
|
|
|
|
| O |
|
|
|
Hole “S” |
|
|
| A |
| F |
| Drill These 11/32” Holes From Back | |
|
|
|
Figure 4. Deflector |
|
|
|
A. Deflector | F. Capscrew, | I. Capscrew, | L. Capscrew, |
B. Pivot Bracket, Front. | |||
C. Pivot Bracket, Back | G. Lockwasher, | J. Lockwasher, 7/16 | M. Lockwasher, 3/8 |
D. Hinge Rod | 5/16 | K. Nut, | N. Nut, |
E. Spring | H. Nut, |
| O. Deflector Bracket |
5