Normal Removal & Installation
NORMAL INSTALLATION & REMOVAL
Installation
1.Insert the upper end of the clear tube into the cart sleeve. Slide the flex hose (C, Figure 20) over the turbo (A) and secure with the large hose clamp (B). The hose should overlap the turbo discharge by 2”- 3”.
The clamp screw should be positioned to the inside as shown to prevent accidental impact and removal of the clamp.
Check that the upper end of the clear tube is not con- tacting the top of the collector cover. If necessary, cut off the clear tube flush with the sleeve (A, Figure 15).
C
B
A
Figure 20. Discharge Tube Installation
A. Turbo Discharge C. Hose
B. Clamp
2.Connect the cart frame (A, Figure 21) to the hitch (B) and install the clevis pins and springs clips (C).
Note: Mounting holes (D) are for left side discharge and mounting holes (E) are for right hand discharge.
WARNING
When the blower assembly is removed from the mower deck, the deflector must be installed as described in Operating Without Collection System.
Removal
DETACH THE COLLECTOR CART
1.Disconnect the flex hose (C, Figure 20) from the turbo discharge (A) by loosening the hose clamp (B). Store the hose and tube assembly inside the cart.
2.Remove the clevis pins (C, Figure 21) from the cart frame (A) and separate the cart and hitch (B). Store the clevis pins and spring clips in the cart frame (A).
E | C |
| |
D |
|
| A |
| B |
Figure 21. Connect Cart to Hitch (Legacy XL Shown)
A. | Cart Frame | D. LH Mounting Holes |
B. | Hitch | E. RH Mounting Holes |
C. Clevis Pins and Spring Clips
WARNING
The deflector is spring loaded. When removing the blower, hold the deflector up. Then allow the deflector to go down into normal operating position (see Figure 29).
DO NOT operate the unit without the deflector in proper mowing position.
REMOVE THE TURBO BLOWER |
|
1. Remove the turbo blower according to the turbo | Figure 22. Deflector - Down Position |
installation instructions. |
|
2.Be sure the deflector is in proper down position before using the unit (see Figure 22).
11
