Initial Assembly & Installation
A B
A
Figure 6. Wheel Assembly (RH Dishcarge Shown)
A. Wheel Assembly | B. Frame |
CART ASSEMBLY
1.Determine if you have a right side or left side dis- charge. Refer to Figures 4 & 5.
B
A
Figure 7. Install |
|
A. | B. Box |
2.Install the wheel assemblies (A, Figure 6) to the frame (B). Place the head of the swivel wheel on the end of the frame. Align the holes and place four 3/8- 16 x 1 hex bolts up through the frame and head of the swivel. Secure with four flat washers (13/32 I.D., 7/8 O.D.) and
3.Install the
4.Turn box upside down and install the frame to the U bracket (Figure 8). Align the two prong end (A) in the frame with the ends of the
5.Turn box with frame upright and install the latch han- dle (A, Figure 9) and two lift handles (B) as follows:
A.Refer to Figure 3. Latch Handle: Place one 5/16-
18 x 1 hex bolt with 5/16 spring washer through the inside of the box. Next place a 5/16 flat washer over the bolt on the outside of the box, the latch handle, a 5/16 flat washer, a 5/16 spring washer and a 5/16 nut and jam nut. Tighten the nuts so that when the latch handle turns the bolt and nut will not turn. (Be sure the cups of the spring washers are facing toward the box surface on both sides.)
B.Refer to Figure 3. Lift Handles: Install the two lift handles on the outside of the box. Place two
D |
Figure 8. Install Frame (RH Dishcarge Shown) A. Prong End
A
B
Figure 9. Install Latch Handle
(RH Dishcarge Shown) |
|
A. Latch Handle | B. Lift Handle |
8