A |
Figure 10. Install Support Tube
A.Support Tube
6.Install support tube (A, Figure 10) inside the box. Align each end of the support tube with the two holes at the front corner side of the box. Place one
COVER ASSEMBLY
1.Unfold the cover and spread it out on a flat, clean surface. The two 3/8 inch rods are threaded through two sleeves inside the cover. The rod with the two bent ends is called the frame rod (B, Figure 11), since it lays on top of the box's frame. The rod with the two eyebolt ends is called the support rod, since it supports the top, rear side of the cover.
2.Thread the frame rod (B, Figure 11) through the bot- tom sleeve of the cover so that the two bent ends protrude through the openings on each side. The openings (A) of the sleeve are found next to the black cord loops.
3.Thread the support rod (A, Figure 12) through the sleeve inside the cover.
4.Pick up the cover by holding the rods and place the support rod inside the frame rod before hooking the frame rod (A, Figure 13) through the eyelet of the support rod (B) on each end.
5.Place the cover assembly over the support tube. Insert the frame rod with the support rod attached through the hole in the support tube and secure with a flat washer and cotter circle (A, Figure 14) on each side.
Initial Installation & Assembly
B
| A |
| |
Figure 11. Install Frame Rod | |
A. Opening | B. Frame Rod |
A
Figure 12. Install Support Rod
A. Support Rod
A
B
Figure 13. Connect Frame Rod and Support Rod
A. Frame Rod | B. Support Rod |
A
Figure 14. Secure Rods
A. Safety Clip
9
