Snapper 1695169, 1733866 manual Component Installation

Component Installation

A

C

B

Figure 5. Install Mounting Plate

A.Mounting Plate

B.Locknuts, 5/16-18

C.Carriage Bolts, 5/16-18 x 5/8

Component Installation

INSTALL MOUNTING PLATE

1.Install mounting plate (A, Figure 5) to mower deck as shown. Secure with 5/16-18 x 5/8 carriage bolts (C) and 5/16-18 locknuts (A).

LOWER CHUTE ROD AND PIN INSTALLATION

1.Insert the head of pin (A, Figure 6) through front hole of lower chute (D). Secure with 1/4-20 x 5/8 carriage bolt (B) and 1/4-20 lock nut (C) as shown.

2.Install the rod (H) to lower chute (D) using 5/16-18 x 1 capscrew (J) and 5/16-18 locknut (G) for front holes. Use 5/16-18 x 1-1/4 capscrew (I) and 5/16-18 locknut (G) as shown. Tighten hardware.

3.Install the rubber strap (F) onto capscrew (I) securing with 5/16-18 locknut as shown.

HANDLE INSTALLATION

1.Install handle (A, Figure 7) using 1/4-20 x 1/2 screw and 1/4-20 locknut (B) for rear hole. Use 1/4-20 x 1 screw (D) as shown. Tighten hardware.

	C	B
D		A
		E
		F
		G
		G
		H
J		I

Figure 6. Lower Chute to Boot Installation

A.Pin, Latch

B.Carriage Bolt, 1/4-20 x 5/8

C.Locknut, 1/4-20

D.Lower Chute

E.Locknut, Center Lock, 5/16-18

F.Strap, Rubber

G.Locknuts, Whiz Lock, 5/16-18

H.Rod, Boot Mount

I.Capscrew, Hex Head, 5/16-18 x 1-1/4

J.Capscrew, Hex Head, Thin, 5/16-18 x 1

FB

A

E

C

B

D

2.Install strap (E) to screw (D) securing with 1/4-20 locknut (F).

Figure 7. Handle to Tube Installation

A.Handle

B.Locknuts, KEPS, 1/4-20

C.Screw, Slotted, 1/4-20 x 1/2

D.Screw, Slotted, 1/4-20 x 1

E.Strap, Rubber

F.Locknut, Center Lock, 1/4-20

6