General
Operating Instructions
Checks Before Starting
1.Refer to the Maintenance & Adjustments sections of this manual and perform any needed service. Also, refer to the tractor Operator’s Manual and perform any required service.
2.Remove any objects from the work area which might interfere with plowing activity.
3.Adjust the skid shoes to desired height. See Skid Shoe Adjustment.
4.Make sure all hardware is present and secure.
Engine & Ground Speed Selection
Always run the engine at full throttle.
Set tractor speed to obtain the needed power to move material. Operate at a safe speed, depending on condi- tions, so that you have complete control of the tractor. Rear wheel weights and chains are recommended for slippery surfaces.
A weight box is recommended for additional traction.
Transporting
For maximum ground clearance, transport the blade to and from work areas fully raised and angled straight ahead.
Starting & Stopping
1.Start the tractor engine. Set engine throttle to full.
2.Raise the attachment lift and travel to the work site.
3.Set the angling control to the desired angle.
4.Lower the attachment lift and begin plowing.
5.Raise the plow before backing up.
6.To stop the tractor, set ground speed to neutral and set the parking brake. Before leaving the seat, stop the engine, set the parking brake, remove the key, and wait for all moving parts to stop.
WARNING
Perform the Safety System Interlock test found in your tractor Operator’s Manual. If tractor does not pass the test, do not operate the tractor. See your authorized dealer. Under no circumstances should you attempt to defeat the safety system.
Use caution when plowing a snow covered area. Snow can cover objects such as curbs,
To prevent an explosion or fire, never store the tractor with fuel in the tank inside a building where an ignition source is present.
IMPORTANT NOTE
To prevent damage to the unit, always raise the dozer blade BEFORE turning or backing up.
DANGER
OPERATING ON SLOPES CAN BE DANGEROUS
Never operate on slopes greater than 17.6% (10°) which is a rise of
Operate the unit at a slow ground speed when driving onto slope. Avoid using brakes to control ground speed.
When operating on slopes that are greater than 15 % (8.5°) but less than 17.6%, use additional wheel weights or counterweights.
In addition to counterweights, use extra caution when operating on slopes. Drive UP and DOWN the slope, never across the face, use caution when changing directions and DO NOT START OR STOP ON SLOPE.
For additional traction, tire chains and a weight box can be added. Maximum weight added to tractor should not exceed 35 lbs. per wheel and 100 additional lbs. in weight box.
4
