DEFLECTOR
The distance of the discharged snow is mainly controlled by the position of the deflector (Figure 6).
The more the deflector is tilted UP, the farther snow will be thrown. Loosen the deflector knob, tilt the deflector UP or DOWN, and then retighten the knob when the desired angle has been chosen.
Operation
Chute
Deflector Knob
Chute
Deflector
Figure 6. Chute Deflector Adjustment
SCRAPER BAR & SKID SHOES
On smooth surfaces such as concrete or asphalt, the scraper bar should scrape the surface. On surfaces such as gravel, the scraper bar should be high enough so that it will not pick up gravel or debris.
The height of the scraper bar is controlled by raising or lowering the skid shoes (See Figure 7).
1.To raise the scraper bar height, rest the scraper bar on a strip of wood equal in thickness to the desired height.
2.Make sure the scraper bar is parallel to the ground surface.
3.Loosen the skid shoe nuts and let the skid shoes drop to the surface.
4.Tighten the nuts, making sure the skid shoes are adjusted equally and are parallel to the surface.
5.To lower the height of the scraper bar, raise the skid shoes.
6.If the scraper bar becomes worn, it can be replaced by removing the hardware attaching it to the snowthrower.
The scraper bar is adjustable. (See Figure 8). If desired scraper bar height adjustment cannot be achieved solely by raising or lowering the skid shoes:
1.Loosen the nuts securing the scraper bar to the auger housing, and raise or lower the scraper bar until desired height is achieved.
2.Tighten the nuts, making sure the scraper bar is parallel with the bottom edge of the auger housing.
Scraper | Skid Shoe | |
Bar | ||
Nuts | ||
|
Skid Shoe
Figure 7. Skid Shoe Adjustment
Scraper Bar |
Nuts |
Scraper |
Bar |
Figure 8. Scraper Bar Adjustment
15
