Operation (Continued)
Starting and Operation | 7. After the engine starts, move the engine speed control |
Engine (Electric Start) | to the “FAST” position and allow a brief |
engine runs smooth. |
IMPORTANT: When the ignition key is turned to “START”, the engine will turn over, but will not start unless the Clutch/Brake pedal is pressed all the way down, and the Blade Lever is in the “OFF” position. The operator should be in the seat.
Start the engine as follows:
1.Open the vent (B, Figure 2) on the fuel filler cap (A) by turning counterclockwise.
IMPORTANT: Failure to open the vent on the fuel filler cap can cause the engine to stall.
2.Move the transmission shift lever to the (N) Neutral position. Refer to the section entitled “Wheel Drive”.
IMPORTANT: DO NOT start the engine with the transmission shift lever in a drive position.
! | WARNING | ! |
It is possible to start the engine with the transmission shift lever in a drive position. Follow starting instructions carefully.
2.Make certain the Blade Lever (A, Figure 4) is in the “OFF” position.
A |
Figure 4: Blade lever (in ‘Off’ position)
3.Press the Clutch/Brake Pedal (A, Figure 5) all the way down and hold while starting the engine.
5.Move the engine speed control (A, Figure 6) to the choke position (B) to start a cold engine.
6.Turn the ignition key (A, Figure 7) to the “START” position until the engine starts.
NOTE: If after 5 seconds of cranking the engine does not start, release the key, make sure the Clutch/Brake Pedal is fully depressed, and attempt starting again after waiting for approximately 20 seconds.
A |
Figure 5: Engaging the clutch/brake pedal
B |
A |
Figure 6: Engine speed control
A |
Figure 7: Ignition key
(Continued on Next Page)
Operation
7
