![](/images/new-backgrounds/1104112/10411211x1.webp)
Snapper 5600W Portable Generator
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Remove Generator From Carton
1.Set the carton on a rigid flat surface with “This Side Up” arrows pointing upward.
2.Carefully open the top flaps of the shipping carton.
3.Cut down corners at one end of carton from top to bottom and lay that side of carton down flat.
4.Remove all packing material, carton fillers, etc.
5.Remove the generator from the shipping carton.
Carton Contents
Check all contents against those listed below:
•Main unit
•Engine oil
Figure 1 — Install Wheel Kit
•Owner’s manual
•Engine manual
•Wheel kit
If any parts are missing or damaged, call the generator helpline at
INSTALL WHEEL KIT
NOTE: While the wheel kit is designed to greatly improve the portability of your generator, it is not intended for
You will need a 1/2" or 13mm socket wrench, a 1/2" or 13mm open end wrench, a 7/16" socket wrench, 7/16" open end wrench and a
NOTE: Adjustable wrenches may be substituted for open end wrenches.
Install the 10” Wheel Kit as Follows:
1.Place the bottom of the generator cradle on a flat, even surface.Temporarily place unit on blocks to ease assembly.
2.Slide axle through both axle mounting brackets on cradle frame, as shown in Figure 1.
3.Slide a wheel over the axle.
Hex Nut
Handle Assembly
Use existing hardware to attach left side of support leg to unit
Cap Screw
Hex Nut | Axle |
Cap Screw
Wheel
Flat Washer
Support Leg
Vibration Mount
Hex Nut
Cap Screw
6