319 Single Stage Snowthrower
Unboxing & Assembly
1.Using a utility knife, open the box and remove the snowthrower.
IMPORTANT NOTE
When removing the snowthrower from the box and unfolding the handle bars
DO NOT PINCH THE AUGER CONTROL CABLE IN THE HANDLE BARS.
2.The right side upper handle is bolted to the outside of the lower handle for shipping purposes. Unbolt and move the right side upper handle to the inside of the lower handle. Reinstall the bolt and knob. Lift up the folding handle to align it with lower handle and tighten the wing knobs securely as shown in Figure 1.
3.Install the lower chute handle onto the discharge chute with two hex head capscrews (Figure 2).
4.Install the chute/handle assembly onto the discharge opening and secure with three carriage bolts and nuts (Figure 2). Tighten all hardware securely. Do not overtighten.
Figure 1. Install Handle Bars
Figure 2. Install Discharge Chute
TP | 4 | 4/2003 |