Section 4 - ADJUSTMENTS & REPAIR

WARNING

DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and vent must be closed securely to prevent fuel spillage.

4.2MOWER DECK & COMPONENT ADJUSTMENTS 4.2.5. MOWER DECK ADJUSTMENT

(Front to Rear Levelness)

Before making deck leveling adjustments, check the tire pressure. Front tires 12 psi, rear tires 12 psi. If tires are properly inflated and mowing is still uneven, adjust side-to-side deck levelness as follows: With the Rear Engine Rider on a smooth, level surface, rotate blade until blade tips are at front and rear of deck. Measure the distance from blade tips to floor. The distance should be the same, or the rear 1/8” to 1/4” lower than the front. If the rear blade tip is higher or is more than 1/4” lower than the front, proceed with adjustment.

1.Remove rear hanger chains.

2.Turn each hanger pivot the same number of rotations on the eyebolt to raise or lower the rear of the deck. See Figure 4.5.

3.Reinstall rear hanger chains and measure blade tips again.

4.Repeat steps “1” through “3” until proper levelness is obtained.

REMOVE REAR HANGER

CHAINS

HAIRPIN

4.2MOWER DECK & COMPONENT ADJUSTMENTS 4.2.6. CUTTING HEIGHT ADJUSTMENT

The cutting height range of the mower can be adjusted.

1.Place the Rear Engine Rider on a smooth, level surface.

2.Place blocks under mower deck. Lower deck with deck lift lever until weight of mower is supported on the blocks.

3.Loosen lift quadrant mounting bolts. Raise or lower lift quadrant as desired. See Figure 4.6.

NOTE: Raise lift quadrant to increase cutting height range. Lower lift quadrant to decrease cutting height range.

4.Tighten lift quadrant mounting bolts securely.

RAISE OR

LOWER LIFT

QUADRANT AS

DESIRED

LOOSEN MOUNTING

BOLTS

FIGURE 4.6

WASHER

FIGURE 4.5

23

Page 23
Image 23
Snapper 421823BVE, 422023BVE important safety instructions Front to Rear Levelness