Section 2 - OPERATING INSTRUCTIONS
2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE 2.4.4. PARK BRAKE
1.Engage park brake by pushing clutch/brake pedal “DOWN” and moving the park brake latch over to the “ENGAGED” position. While holding the park brake latch “ENGAGED”, release clutch/brake pedal to set park brake. See Figure 2.16.
CLUTCH/BRAKE
PEDAL
PARK BRAKE
LATCH SHOWN
ENGAGED
FIGURE 2.16
2.Release park brake by pushing down on the clutch/brake pedal to release park brake latch. See Figure 2.17.
CLUTCH/BRAKE
PEDAL SHOWN
DISENGAGED
2.5.CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height as desired to any one of six positions using deck lift lever. When in desired height of cut, release latch, then try to move deck lift lever to ensure lift lever latch is fully engaged. See Figure 2.18.
LIFT LEVER LATCH
DECK LIFT
LEVER
FIGURE 2.18
WARNING
DO NOT park the machine on slopes.
PARK BRAKE
LATCH SHOWN
IN “OFF”
POSITION
FIGURE 2.17
11
