A s s e m b l y
GENERAL
All of the major assembly procedures on your new Chipper/Shredder were performed at the factory, and only the items listed in this section need to be taken care of to make your unit fully operational.
TOOLS REQUIRED
-1/2" Box Wrench or Socket
-7/16" Box Wrench or Socket
-1/4" Hex Wrench
HARDWARE DESCRIPTION
The hardware pack packaged with your unit contains the items listed below and possibly additional hardware required for other models:
Description | Qty. |
- | 3 |
- | 2 |
- | 2 |
- 5/16 Flat Washer | 4 |
- 5/16 Lockwasher | 1 |
- | 2 |
- | 2 |
Be sure to clean all hardware threads of paint and deb is before assembling.
CHIPPER CONE |
| for | |
1. See figure 1. Position the chipper c ne assembly base | |||
over the three | |||
the engine plate, and attach using (3) | |||
nuts. |
|
|
|
2. Tighten whiz nuts securely using a box or sock t | |||
wrench. | Not |
|
|
|
|
| |
HANDLE |
|
|
|
|
| Figure 3. Attaching Hopper to the Rotor | |
Reproduction |
1.Lift the hopper handle up until the outer holes in the handle align with the holes in the shredder hopper. See figure 2.
2.Secure the Hopper Handle in position using (2)
3.Tighten all four screws securely.
Figure 4. Installing Hardware Inside Hopper8