CAUTION
Avoid injury! Mower blades are sharp.
•Always wear gloves when handling the mower blades.•Always wear safety eye protection when grinding.Regular Maintenance
A
B
1. | Sharpen the mower blades with grinder, hand file, or | Figure 29. Sharpening the Mower Blade | |
| electric blade sharpener. | ||
| A. Mower Blade Bevel | ||
2. | Sharpen the mower blade by removing an equal amount | B. Mower Blade Cutting Edge | |
| of material from each end of the mower blade. |
|
|
3. | Keep the original bevel (A, Figure 29) when grinding. |
|
|
|
| ||
| DO NOT change the mower blade bevel. |
|
|
4. | The mower blade should have a maximum 1/64” (0,40 |
|
|
| mm) cutting edge (B) or less. |
|
|
5. | Balance the mower blades before installing. |
|
|
|
| ||
|
|
|
|
Balancing the Mower Blades | Reproduction |
| |||
CAUTION |
|
| orf |
| |
|
|
|
|
| |
Avoid injury! Keep mower blades balanced. |
|
|
| A | |
• An unbalanced mower blade can create excessive |
|
|
| ||
vibration and damage the unit or cause mower blade |
|
| |||
failure. |
|
|
|
|
|
1. Clean the mower blade to remove any dried grass or |
| Figure 30. Balancing the Mower Blade |
| ||
other debris. |
|
|
|
| |
|
|
| A. Nail |
| |
2. See Figure 30. Put the mower blade on a nail in a vise |
| ||||
|
| ||||
and turn the mower blade to the horizontalNotposition. |
|
|
| ||
3. Check the balance of the mower blade. If either end |
|
|
| ||
of the mower blade moves downward, shar | n the |
|
|
| |
heavy end until the mower blade is balanc d. S |
|
|
| ||
Sharpening the Mower Blades for prop r sharp ning |
| B | |||
instructions. |
|
|
|
| |
4. Repeat the process until the mower blade remains in the |
|
| |||
horizontal position. |
|
|
|
|
|
Reinstalling the Mower Blades |
|
|
|
|
|
1. Reinstall each mower blade with the air lifts pointing up |
|
| |||
towards the mower deck as shown in Figure 31. Secure |
| A | |||
with the mower blade mounting bolt and flat washer (A |
| ||||
D |
| ||||
& B, Figure 31) and torque to 70 ft. lbs (94 Nm). |
|
| |||
|
|
| |||
2. If there are no flats on the spindle shaft, wedge a |
|
|
| ||
wooden block between the mower blade and the mower |
|
| |||
deck housing to keep the mower blade from turning. |
|
|
| ||
|
|
|
| Figure 31. Tightening the Mower Blade for |
|
|
|
|
| Installation |
|
|
|
|
| A. Mower Blade Mounting Bolt |
|
|
|
|
| B. Flat Washer |
|
|
|
|
| C. Mower Blade Air Lift (Points Up For Installation) | |
|
|
|
| D. 4 X 4 Wooden Block |
|
27