Snapper 5201m, 5201e Fuel And Oil Mixture, Proper Fuel Mixing Procedure, Controls & Operation

Models: 5201m, 5201e

1 20
Download 20 pages 48.58 Kb
Page 12
Image 12
FUEL AND OIL MIXTURE

FUEL AND OIL MIXTURE

The snowthrower uses a two cycle engine that requires a mixture of fuel (gasoline) and oil for lubrication of engine bearings and other moving parts.

The correct fuel/oil mixture ratio is 50 to 1. Use fuel/oil mixture chart shown.

NOTE: To prevent damage to engine, carefully observe recommended fuel to oil mixing ratio and procedures.

Gasoline and oil must be premixed in a clean fuel container.

Always use fresh, unleaded, winter grade fuel.

Never put plain, unmixed fuel into fuel tank. Shake fuel container each time before filling fuel tank.

Never use “stale” fuel left over from last season or stored for long periods.

DO NOT USE MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.

PROPER FUEL MIXING PROCEDURE

1.Fill approved clean fuel container one quarter full with fresh unleaded fuel - one quart (one liter) in a one gallon (4 liter) container.

2.Pour recommended amount of high quality two cycle oil — 2.5 ounces (80 ml) into fuel container for one gallon (4 liters) of fuel. (NOTE: DO NOT USE

MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.)

3.Reinstall cap on the fuel container and shake con- tainer vigorously so oil mixes with gasoline.

4.Unscrew cap and fill container with fuel. Shake con- tainer again.

5.Remove fuel tank cap and carefully pour mixed fuel into the fuel tank, filling to 1/2 inch (1.5 cm) below filler neck to allow room for expansion. Never put plain, unmixed fuel into fuel tank. Shake fuel con- tainer each time before filling fuel tank.

Controls & Operation

PROPER FUEL MIXING PROCEDUREManual background WARNING

Gasoline is highly flammable and must be handled with care. Follow these fuel handling precautions:

Use an approved fuel container.

DO NOT run the unit indoors. DO NOT fill fuel tank indoors or while engine is running.

Allow engine to cool for at least ten minutes before refueling.

Wipe up any spilled fuel before starting the engine.

Fuel vapors can travel to distant ignition sources. Keep fuel and fuel vapors away from ignition sources.

FUEL TO OIL MIXTURE CHART (50:1)

U.S.

Imperial

Metric

Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil

Gallons

Ounces

Gallons

Ounces

Liters

Milliliters

1

2.5

1

2.8

4

80 ml

2

5

2

5.6

8

160 ml

5

13

5

14.1

20

400 ml

A

B

 

C

 

D

Figure 7. Proper Fuel Mixing Procedure

A.Fill Container with 1 Quart (1 Liter) of fuel

B.2.5 Ounces (80 ml) of two-cycle oil

C.Combine in container, then shake container

D.Additional fuel brings total to 1 Gallon (4 liters)

11

Page 12
Image 12
Snapper 5201m, 5201e manual Fuel And Oil Mixture, Proper Fuel Mixing Procedure, Controls & Operation