Snapper 5201m, 5201e manual Assembling the Snowthrower, Tools Required, Assembly Procedure

Assembling the Snowthrower

	A
	C
	D
B	E

Figure 1. Assembly of Discharge Chute

A. Discharge Chute	D. Nuts
B. Carriage Bolts	E. Rotating Ring
C. Washers

TOOLS REQUIRED

•Socket or Wrench Set

•Pair of Pliers

ASSEMBLY PROCEDURE

If your unit was not previously assembled, see Figures 1 and 2, and follow the steps below to assemble the unit:

1.Install the discharge chute on to the rotating ring located on the auger housing. Secure with the three 5/16 inch carriage bolts, flat washers and nylock nuts found in the parts bag (the bolt heads go to inside of of the rotating ring, with washers and nuts on the out- side). Note, install the rear bolt first for easier align- ment.

2.Tighten bolts securely with a wrench.

3.Lift up folding handle to align it with lower handle and tighten the wing knobs securely as shown in Figure 3.

4.Insert clean-out tool into holders on left handle.

A

B

C

Figure 2. Handles	Figure 3. Lift Handles and Lock Wing Knobs
A. Handle B. Wing Knobs	C. Clean-out Tool

7