Features & Controls

 

Parking Brake

 

Fuel Tank Cap

 

 

 

 

 

 

 

DISENGAGE

Releases the parking brake.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ENGAGE

Locks the parking brake.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To remove the cap, turn counterclockwise.

Fuel Level Gauge

Displays the fuel level in the tank.

Pull the parking brake lever up to engage the parking brake. Push the lever down to disengage the parking brake. NOTE: To start the unit the parking brake must be engaged.

PTO (Power Take Off) Switch

The PTO switch engages and disengages the mower. Pull

UP on the switch to engage, and push DOWN to disengage.

Deck Lift Pedal, Cutting

 

 

 

Height Adjustment Pin & Deck

 

 

Lift Lock Lever

 

 

 

 

These control the cutting height of the mower deck.

 

Fuel Shut Off Valve

Depress the pedal until it locks into the 4-1/2” (11,47 cm)

 

 

position. Place the adjustment pin in the desired cutting

 

Turning the handle

the desired position determines which

height and release the lift lock lever.

 

 

tank will be supply ng fuel. With the handle pointing LEFT,

 

 

 

it will draw fuel from

he left hand tank. With the handle

Throttle Control

 

orfpointing RIGHT, it will draw fuel from the right hand fuel

 

 

tank. With the handle pointing towards the engine, it will

The throttle controls engine speed. Move the throttle

 

sh t f el flow to the engine.

forward to increase engine speed and back to decrease

 

S/N: 2014509322 & Above:

engine speed. Always operate at FULL throttle.

 

Choke

Not

 

 

 

 

 

 

 

Close the choke for cold starting. Open the choke once the

 

 

engine starts. A warm engine may not require choking. Pull

 

 

the knob UP to close the choke. Push to knob DOWN to

 

 

 

open the choke.

Reproduction

Transmission Oil Fill

 

 

 

 

This unit is equipped with two transmission oil reservoirs. The transmission oil reservoirs are located beneath the operator’s seat and in front of the engine. Transmission oil is added through the transmission oil reservoirs. It also serves as extra holding capacity as the transmissions heat up and the oil expands. See CHECK TRANSMISSION OIL LEVEL for oil level check and fill procedures.

12

www.Snapper.com