or frame. Then remove the other end of the same cable from the booster battery.
11. Remove the other cable by disconnecting at the discharged battery first and then disconnect the opposite end from the booster battery.
12. Discard the damp cloths that were placed over the battery vent caps.
AA
D
B
ED
C
F
Regular Maintenance
WARNING
For your personal safety, use extreme care when jump starting. Never expose battery to open flame or electric spark – battery action generates hydrogen gas which is flammable and explosive. Do not allow battery acid to contact skin, eyes, fabrics, or painted surfaces. Batteries contain a sulfuric acid solution which can cause serious personal injury or property damage.
When removing or installing battery cables, disconnect the negative cable FIRST and reconnect it LAST. If not done in this order, the positive terminal can be shorted to the frame by a tool.
To avoid engine damage, do not disconnect battery while engine is running. Be sure terminal connections are tight before starting.
Figure 45. Jump Starting | Reproduction | |||
| This | for | |||
| Callout | Description |
|
|
|
A | To Starter Switch |
|
|
|
B | Starting Vehicle Battery |
| Not |
|
C | To Ground |
|
|
|
D | Jumper Cable |
|
|
|
E | Discharged Vehicle Battery |
|
| |
F | Engine Block |
|
|
|
| Make sure vehicles do not touch. |
| ||
|
|
|
|
|
|
|
|
| |
WARNING |
|
|
| |
| Any procedure other than the prec ding could |
| |||
| result in: |
|
|
| |
| (1) personal injury caused by electrolyte |
| |||
| squirting out the battery vents, |
| |||
(2)personal injury or property damage due to battery explosion,
(3)damage to the charging system of the booster vehicle or of the immobilized vehicle.
Do not attempt to jump start a vehicle having a frozen battery because the battery may rupture or explode. If a frozen battery is suspected, examine all fill vents on the battery. If ice
can be seen or if the electrolyte fluid cannot be seen, do not attempt to start with jumper cables as long as the battery remains frozen.
37